Table of Contents
Advertisement
Installation instructions
Use these steps to install the CPV5000 into your computer chassis.
1. Follow the instructions in your chassis user manual to remove any outer
cover.
2. Locate the CPV5000 position slot (normally slot one, the far right slot
when viewed from the front).
3. Remove any filler panel (or existing CPU board) that might fill that slot.
4. Install the top and bottom edge of the CPV5000 in the guides of the
chassis.
5. Ensure that the levers of the two injector/ejectors are in the inward
position.
6. Slide the CPV5000 into the chassis until resistance is felt.
7. Simultaneously move the injector/ejector levers in an outward direction.
8. Verify that the CPV5000 is properly seated and secure it to the chassis
using the two screws located adjacent to the injector/ejector levers.
9. Connect the appropriate cables to the CPV5000.
10. Repeat steps 3 through 8 for installing the transition module.
Installation instructions
2-3
2
Advertisement
Table of Contents
