Switches And Jumpers; Table 1-2. Mvme167P Configuration Settings - Motorola MVME167P Installation And Use Manual

Hardware Preparation and Installation
1

Switches and Jumpers

Caution
Caution
1-6
Figure 1-1 on page 1-2
connectors, configuration switches, and various other components on the
MVME167P. Manually configurable jumper headers and configuration
switches on the MVME167P are listed in the following table.
When setting jumpers, avoid touching areas of integrated circuitry; static
discharge can damage circuits.

Table 1-2. MVME167P Configuration Settings

Function
General-Purpose Readable Jumpers (J1)
VME System Controller (J6)
SRAM Backup Power Source (J9)
Serial Port 4 Clock Configuration (J10 and J11)
Petra SDRAM Size (S3)
Board EPROM/Flash Mode (S4)
Note
Headers J2 and J7 are for factory use; they are not available to
customer applications. J2 is used during board manufacture in
programming on-board logic devices. J7 is a thermal sensing
header. It is not used on the MVME167P.
illustrates the placement of the jumper headers,
Computer Group Literature Center Web Site
Factory Default
All Jumpers On
1-2
1-3, 2-4
2-3, 2-3
Varies
Off-Off