Hardware Configuration; Mvme6100 Preparation - Motorola MVME6100 Installation And User Manual

Chapter 1 Hardware Preparation and Installation
Inserting or removing modules with power applied may result in damage to module
Caution
!
components.
Caution
Dangerous voltages, capable of causing death, are present in this equipment. Use
Warning
extreme caution when handling, testing, and adjusting.
Warning

Hardware Configuration

This section discusses certain hardware and software tasks that may need to be performed
prior to installing the board in a chassis.
To produce the desired configuration and ensure proper operation of the MVME6100, you may
need to carry out certain hardware modifications before installing the module.
Most options on the MVME6100 are software configurable. Configuration changes are made by
setting bits in control registers after the board is installed in a system.
Jumpers/switches are used to control those options that are not software configurable. These
jumper settings are described further on in this section. If you are resetting the board jumpers
from their default settings, it is important to verify that all settings are reset properly.

MVME6100 Preparation

Figure 1-1 illustrates the placement of the jumpers, headers, connectors, switches, and various
other components on the MVME6100. There are several manually configurable headers on the
MVME6100 and their settings are shown in
in brackets. For pin assignments on the MVME6100, refer to
4
MVME6100 Installation and Use (V6100A/IH2)
Table 1-2. Each header's default setting is enclosed
Chapter 5, Pin Assignments.