Transportation And Storage; Fig. 4 Fuse Holder - Otto Bock B400 Instructions For Use Manual

To do so, remove the fuse from the protective cover on the
control panel, open the cap of the safety holder and insert
the fuse.
Make sure that the fuse is pressed into the centre of the
spring contacts and that it is not at an angle. Close the cap
until you feel it snap back into place.
1
Fig. 4 Fuse holder
1 Cap, open
2 Fuse, inserted
3 Fuse holder
B400
2 3
5

Transportation and Storage

WARNING
Risk of accident and injury due to improper use for
transportation in motor vehicles for the disabled.
The Otto Bock product B400 Electric Wheel Chair has
not been approved by Otto Bock for use as a seat in mo-
tor vehicles for the disabled!
Users of the product must always transfer to the seats in-
stalled in the motor vehicle with the corresponding vehicle
restraint systems! Non-observance of these instructions
could lead to injury of the user, as well as of all other pas-
sengers in the motor vehicle, in case of an accident.
You can get information on the present state of our meas-
ures from your specialised dealer or on the Otto Bock
Homepage www.ottobock.com.
CAUTION
Risk of injury as a result of not engaging the locks suf-
ficiently. Secure the power wheelchair during transport in
another vehicle by sufficiently tightening the tensioning
straps.
The frame of the power wheelchair has 4 fixing eyelets for
the attachment of the tensioning straps.
05 / 2009
Transportation and Storage
Page 87