Flywheel Installation - KYMCO G-DINK 300i Service Manual

10
. A.C. GENERATOR/STARTER CLUTCH
Remove the starter one-way clutch rollers,
plungers and springs.
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Install the starter idle gear and shaft.

FLYWHEEL INSTALLATION

Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
＊
• Before installation, check and make
sure that the inside of the flywheel is
not contaminated.
Hold the flywheel with the flywheel holder
and tighten the flywheel nut.
Torque: 53.9～63.7N-m
10-5
G-Dink300i
Starter Idle Gear
Shaft
Starter Driven Gear
Key
Flywheel
Groove
Flywheel Holder