Configuring Gvrp - Dell PowerConnect 8024 User Configuration Manual

Command
groupid
protocol group
vlanid
CTRL + Z
show port protocol [all|
groupid
]

Configuring GVRP

Beginning in Privileged EXEC mode, use the following commands to enable
GVRP on the switch and on an interface, and to configure various GVRP
settings.
Command
configure
gvrp enable
interface
interface
gvrp enable
Purpose
Attach a VLAN ID to the protocol-based group identified
by groupid. A group may only be associated with one
VLAN at a time. However, the VLAN association can be
changed.
groupid
• — The protocol-based VLAN group ID, which is
automatically generated when you create a protocol-
based VLAN group with the vlan protocol group
command. To see the group ID associated with the name
of a protocol group, use the show port protocol all
command.
vlanid
• — A valid VLAN ID.
Exit to Privileged EXEC mode.
Display the Protocol-Based VLAN information for either
the entire system or for the indicated group.
Purpose
Enter global configuration mode.
Enable GVRP on the switch.
Enter interface configuration mode for the specified port
interface
or LAG. The
and number, for example tengigabitethernet 1/0/3 or port-
channel 3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Enable GVRP on the interface.
variable includes the interface type
Configuring VLANs
599