Configuring A Port In Trunk Mode - Dell PowerConnect 8024 User Configuration Manual

interface is automatically removed from its previous VLAN membership. You
can configure each interface separately, or you can configure a range of
interfaces with the same settings.
Command
configure
interface
interface
switchport mode access
switchport access vlan
vlan-id
CTRL + Z
show interfaces
interface
switchport

Configuring a Port in Trunk Mode

Beginning in Privileged EXEC mode, use the following commands to
configure an interface as a layer 2 trunking interface, which connects two
switches. Trunk mode ports support traffic tagged with different VLAN IDs.
Untagged received traffic is switched in the native VLAN.
Command
configure
Purpose
Enter global configuration mode.
Enter interface configuration mode for the specified
interface
interface. The
and number, for example tengigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Configure the interface as an untagged layer 2 VLAN
interface.
Configure the interface as a member of the specified
VLAN.
vlan-id
— A valid VLAN ID of the VLAN to which the port
is configured. (Range: 1–4093)
Exit to Privileged EXEC mode.
Display information about the VLAN settings configured
for the specified interface.
Purpose
Enter global configuration mode.
variable includes the interface type
Configuring VLANs
589