Configuring Ipv6 Routing Features (Cli); Configuring Global Ip Routing Settings - Dell PowerConnect 8024 User Configuration Manual

Configuring IPv6 Routing Features (CLI)

This section provides information about the commands you use to configure
IPv6 routing on the switch. For more information about the commands, see
PowerConnect 8024/8024F/8132/8132F/8164/8164F CLI Reference
the
Guide
at support.dell.com/manuals.

Configuring Global IP Routing Settings

Beginning in Privileged EXEC mode, use the following commands to
configure various global IP routing settings for the switch.
Command
configure
sdm prefer dual-ipv4-
and-ipv6 default
ipv6 unicast-routing
limit
ipv6 hop-limit
ipv6 icmp error-interval
burst-interval burst-
[
size
]
exit
Purpose
Enter global configuration mode.
Select a Switch Database Management (SDM) template
to enable support for both IPv4 and IPv6. Changing the
SDM template requires a system reload.
Globally enable IPv6 routing on the switch.
Set the TTL value for the router. The valid range is 0 to
255.
Limit the rate at which IPv4 ICMP error messages are sent.
burst-interval
• — How often the token bucket is
initialized (Range: 0–2147483647 milliseconds).
burst-size
• — The maximum number of messages that
can be sent during a burst interval (Range: 1–200).
Exit to Privileged EXEC mode.
Configuring IPv6 Routing
1083