Configuring L3 Multicast Features (Cli); Configuring And Viewing Ipv4 Multicast Information - Dell PowerConnect 8024 User Configuration Manual

Configuring L3 Multicast Features (CLI)

This section provides information about the commands you use to configure
general IPv4 multicast settings on the switch. For more information about the
commands, see the
Reference Guide

Configuring and Viewing IPv4 Multicast Information

Beginning in Privileged EXEC mode, use the following commands to enable
IPv4 multicast on the switch and to view and configure other general
multicast settings.
Command
configure
ip multicast
source-address
ip mroute
mask rpf-address preference
vlan-id
interface vlan
ip mcast boundary
groupipaddr mask
ip multicast ttl-threshold
ttlvalue
PowerConnect 8024/8024F/8132/8132F/8164/8164F CLI
at support.dell.com/manuals.
Purpose
Enter global configuration mode.
Enable IPv4/IPv6 multicast on the switch.
Create a static multicast route for a source range.
source-address
•
source.
mask
•
source.
rpf-address
•
the source.
preference
•
Enter Interface Configuration mode for the specified
VLAN.
Add an administrative scope multicast boundary
specified by the multicast group IP address
groupipaddr
(
which this multicast administrative boundary is
applicable.
The group IP address valid range is 239.0.0.0 to
239.255.255.255.
Apply a Time to Live (TTL) value to the interface. The
ttlvalue
multicast data packets forwarded through the interface.
— The IP address of the multicast data
— The IP subnet mask of the multicast data
— The IP address of the next hop towards
— The cost of the route (Range: 1–255).
) and group IP subnet mask (
is the TTL threshold which is applied to the
Managing IPv4 and IPv6 Multicast
mask
) for
1233