Configuring And Viewing Pim-Dm For Ipv6 Multicast Routing - Dell PowerConnect 8024 User Configuration Manual

Command
show ip pim interface vlan
vlan-id
show ip pim neighbor
[interface vlan

Configuring and Viewing PIM-DM for IPv6 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to
configure PIM-DM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-DM information.
Command
configure
ip routing
ipv6 unicast-routing
ipv6 pim dense
ip multicast
ip igmp
vlan-id
interface vlan
ipv6 pim
ipv6 enable
ipv6 mld router
ipv6 pim hello-interval
exit
show ipv6 pim
1242
Managing IPv4 and IPv6 Multicast
Purpose
View the PIM-DM information for the specified
interface.
View a summary or all the details of the multicast
vlan-id
| all] table.
seconds
Purpose
Enter global configuration mode.
Enable IP routing. Routing is required for PIM
operation.
Enable IPv6 routing. IPv6 routing is required for
the operation of PIM.
Enable PIM-DM on the switch.
Enable IPv6/IPv6 multicast routing.
Enable IGMP . IGMP is required for PIM to
operate properly.
Enter Interface Configuration mode for the
specified VLAN.
Enable PIM on the interface.
Enable IPv6 on the VLAN.
Enable MLD on the VLAN. MLD is required for
PIM.
Specify the number of seconds (range: 0–65535)
to wait between sending PIM hello messages on
the interface.
Exit to Privileged EXEC mode.
View system-wide PIM information.