Dell PowerConnect 8024 User Configuration Manual page 1245

Command
ip pim rp-candidate vlan
vlan-id group-address group-
mask interval
[interval
ip pim rp-address
group-address group-mask
[override]
ip pim ssm {default |
address group-mask
vlan-id
interface vlan
ip pim hello-interval
ip pim bsr-border
ip pim dr-priority
ip pim join-prune-interval
interval
Purpose
Configure the router to advertise itself to the BSR
router as a PIM candidate Rendezvous Point (RP) for
] a specific multicast group range.
vlan-id
•
group-address
•
group-mask
•
address.
interval
•
advertisement interval. The range is from 1 to 16383
seconds. The default value is 60 seconds.
rp-address
(Optional) Statically configure the RP address for one
or more multicast groups. Only one RP address can be
used at a time within a PIM domain
The optional keyword override indicates that if there
is a conflict, the RP configured with this command
prevails over the RP learned by BSR.
group-
Define the Source Specific Multicast (SSM) range of
} IP multicast addresses.
• default — Defines the SSM range access list to
232.0.0.0/8.
group-address group-mask
•
Enter Interface Configuration mode for the specified
VLAN.
seconds
Specify the number of seconds (range: 0–65535) to
wait between sending PIM hello messages on the
interface.
Prevent bootstrap router (BSR) messages from being
sent or received through the interface.
priority
Set the priority value for which a router is elected as
the designated router (DR). The election priority
range is 0–2147483647.
Configure the interface join/prune interval for the
PIM-SM router. The interval range is 0–18000
seconds.
— A valid VLAN ID.
— Group IP address supported by RP .
— Group subnet mask for group
— (Optional) Indicates the RP candidate
Managing IPv4 and IPv6 Multicast
— defines the SSM range.
1245