Configuring Interface Queue Drop Probability - Dell PowerConnect 8024 User Configuration Manual

CLI Command
cos-queue strict
cos-queue random-detect
queue-id
exit
exit
show interfaces cos-queue

Configuring Interface Queue Drop Probability

Beginning in Privileged Exec mode, use the following commands in to
configure characteristics of the drop probability and view related settings. The
drop probability supports configuration in the range of 0 to 10%, and the
discrete values 25%, 50%, and 75%. Values not listed are truncated to the next
lower value in hardware.
CLI Command
configure
interface
interface
random-detect queue-parms
queue-id queue-id
[
min1 min2 min3 min4
thresh
max1 max2 max3
max-thresh
max4
drop-prob
prob3 prob4
exit
exit
show interfaces random-detect Display WRED parameters for an interface or all
1156
Configuring Class-of-Service
Description
queue-id
Activate the strict priority scheduler mode for each
specified queue. The
Set the queue management type for the specified
queue to WRED. The no version of this command
resets the value to taildrop.
Exit to Global Config mode.
Exit to Privilege Exec mode.
Display the class-of-service queue configuration for a
specified interface or all interfaces.
Description
Enter Global Configuration mode.
Enter Interface Configuration mode, where
interface
unit/slot/port
Configure the maximum and minimum thresholds
...] min-
for one or more queue IDs on a WRED-enabled
interface queue.
You can also use this command in Global
prob1 prob2
Configuration mode to configure the same
parameters for one or more queues on all interfaces.
Exit to Global Config mode.
Exit to Privilege Exec mode.
interfaces.
queue-id
value ranges from 0 to 6.
is replaced by tengigabitethernet
or port-channel
port-channel number
.