Dell PowerConnect 8024 User Configuration Manual page 1248

Command
ipv6 pim ssm {default |
group-address/prefix-length
vlan-id
interface vlan
ipv6 pim
ipv6 enable
ipv6 mld router
ipv6 pim hello-interval
seconds
ipv6 pim bsr-border
ipv6 pim dr-priority
ipv6 pim join-prune-interval
interval
exit
exit
show ipv6 pim
show ipv6 pim interface vlan
vlan-id
show ipv6 pim neighbor
[interface vlan
1248
Managing IPv4 and IPv6 Multicast
Purpose
Define the Source Specific Multicast (SSM) range of
} IPv6 multicast addresses.
• default — Defines the SSM range access list to
FF3x::/32.
group-address/prefix-length
•
range.
Enter Interface Configuration mode for the specified
VLAN.
Enable PIM on the VLAN.
Enable IPv6 on the VLAN.
Enable MLD on the VLAN. MLD is required for IPv6
PIM.
Specify the number of seconds (range: 0–65535) to
wait between sending PIM hello messages on the
interface.
Prevent bootstrap router (BSR) messages from being
sent or received through the interface.
priority
Set the priority value for which a router is elected as
the designated router (DR). The election priority
range is 0–2147483647.
Configure the interface join/prune interval for the
PIM-SM router. The interval range is 0–18000
seconds.
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View system-wide PIM information.
View the PIM information for the specified interface.
View a summary or all the details of the multicast
vlan-id
| all] table.
— defines the SSM