Configuring Ospf Interface Settings - Dell PowerConnect 8024 User Configuration Manual

Configuring OSPF Interface Settings

Beginning in Privileged EXEC mode, use the following commands to
configure per-interface OSPF settings.
Command
configure
vlan-id
interface vlan
area-id
ip ospf area
[secondaries none]
number-
ip ospf priority
value
ip ospf retransmit-
seconds
interval
ip ospf hello-interval
seconds
Purpose
Enter global configuration mode.
Enter Interface Configuration mode for the specified
VLAN.
Enables OSPFv2 on the interface and sets the area ID of
an interface. This command supersedes the effects of
network area command.
area-id
The variable is the ID of the area (Range: IP
address or decimal from 0 –4294967295)
Use the secondaries none keyword to prevent the interface
from advertising its secondary addresses into the OSPFv2
domain.
Set the OSPF priority for the interface. The
variable specifies the priority of an interface (Range: 0 to
255).
The default priority is 1, which is the highest router
priority. A value of 0 indicates that the router is not
eligible to become the designated router on this network.
Set the OSPF retransmit interval for the interface.
seconds
The variable is the number of seconds between
link-state advertisements for adjacencies belonging to this
router interface.
This value is also used when retransmitting database
descriptions and link-state request packets. Valid values
range from 0 to 3600 seconds (1 hour).
Set the OSPF hello interval for the interface. This
parameter must be the same for all routers attached to a
network.
seconds
The variable indicates the number of seconds to
wait before sending Hello packets from the interface.
(Range: 1–65535).
Configuring OSPF and OSPFv3
number-value
991