Configuring And Viewing Pim-Sm For Ipv4 Multicast Routing - Dell PowerConnect 8024 User Configuration Manual

Configuring and Viewing PIM-SM for IPv4 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to
configure PIM-SM for IPv4 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-SM information.
Command
configure
ip routing
ip pim sparse
ip igmp
ip multicast
ip pim bsr-candidate vlan
vlan-id hash-mask-length
priority
[ ] [interval
1244
Managing IPv4 and IPv6 Multicast
Purpose
Enter global configuration mode.
Enable ip routing. Routing is required for PIM
operation.
Enable PIM-SM as the multicast routing protocol on
the switch.
Enable IGMP .
Enable IPv4/IPv6 multicast routing.
Configure the switch to announce its candidacy as a
bootstrap router (BSR).
interval
]
vlan-id
•
hash-mask-length
•
be ANDed with the group address before the hash
function is called. All groups with the same seed
hash correspond to the same RP . For example, if this
value is 24, only the first 24 bits of the group
addresses matter. This allows you to get one RP for
multiple groups. (Range 0–32 bits).
priority
•
BSR with the higher priority is preferred. If the
priority values are the same, the router with the
higher IP address is the BSR. (Range 0–255).
interval —
•
advertisement interval. The range is from 1 to 16383
seconds. The default value is 60 seconds.
— A valid VLAN ID.
— The length of a mask that is to
— The priority of the candidate BSR. The
(Optional) Indicates the BSR candidate