Configuring And Viewing Igmp Proxy - Dell PowerConnect 8024 User Configuration Manual

Configuring and Viewing IGMP Proxy

Beginning in Privileged EXEC mode, use the following commands to
configure the upstream VLAN routing interface as an IGMP proxy. The
IGMP proxy issues host messages on behalf of the hosts that have been
discovered on IGMP-enabled interfaces. The upstream interface is the
interface closest to the root multicast router, which should be running IGMP .
NOTE:
Configure only the upstream interface as the IGMP proxy. IGMP should
be enabled on all downstream interfaces. IP routing and IP multicast must be
enabled on the switch for the IGMP proxy feature to operate.
Command
configure
vlan-id
interface vlan
ip igmp-proxy
ip igmp-proxy reset-status
ip igmp-proxy unsolicit-rprt-
seconds
interval
CTRL + Z
show ip igmp-proxy
show ip igmp-proxy interface
show ip igmp-proxy groups
1238
Managing IPv4 and IPv6 Multicast
Purpose
Enter global configuration mode.
Enter Interface Configuration mode for the
specified VLAN.
Configure the interface as an IGMP proxy
interface.
(Optional) Reset the host interface status
parameters of the IGMP Proxy.
Configure the unsolicited report interval for the
IGMP proxy interface.
seconds
The range for
Exit to Privileged EXEC mode.
View a summary of the host interface status
parameters.
View a detailed list of the host interface status
parameters. This command displays information
only when IGMP Proxy is operational.
View a table of information about multicast
groups that IGMP Proxy reported. This
command displays information only when IGMP
Proxy is operational.
is 0–260 seconds.