Dell PowerConnect 8024 User Configuration Manual page 590

Command
interface
interface
switchport mode trunk
switchport trunk
vlan-
{allowed vlan
list
|native vlan
CTRL + Z
590
Configuring VLANs
Purpose
Enter interface configuration mode for the specified
interface. The
and number, for example tengigabitethernet 1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
tengigabitethernet 1/0/8-12 configures interfaces 8, 9, 10,
11, and 12.
Configure the interface as a tagged layer 2 VLAN interface.
Set the list of allowed VLANs that can receive and send
traffic on this interface in tagged format when in trunking
vlan-id
} mode.
• allowed
can receive and send traffic on this interface in tagged
format when in trunking mode. Separate non-consecutive
VLAN IDs with a comma and no spaces. Use a hyphen to
designate a range of IDs.
vlan-list
The
atom
• all—Specifies all VLANs from 1 to 4093. This keyword
is not allowed on commands that do not permit all
VLANs in the list to be set at the same time.
• add—Adds the list of VLANs to the allowed set.
• remove—Removes the list of VLANs from the allowed
set. Removing the native VLAN from a trunk port
forces the port to allow tagged packets only.
• except—Allows all VLANs other than those in the list.
vlan-atom
•
4093 or a continuous range of VLANs described by two
VLAN numbers, the lesser one first, separated by a
hyphen.
• native
received on this interface are switched in the native
VLAN. Transmitted packets in this VLAN are sent
untagged.
Exit to Privileged EXEC mode.
interface
variable includes the interface type
vlan-list
— Set the list of allowed VLANs that
format is all | [add | remove | except]
vlan-atom
[ ...] where:
—Either a single VLAN number from 1 to
vlan-id
— The untagged VLAN. Untagged packets
vlan-