Table of Contents
Advertisement
Installing EMU Microcode
Restarting the Controller
C–6 UltraSCSI RAID Enclosure
Complete the procedure in Table C–5 to restart the controller after the
microcode upgrade is loaded.
Table C–5 Restarting the Controller
1.
Remove the 8-pin RJ45 connector from the EMU UART connector.
2.
On each controller, press and hold-in the reset button and reseat its
PCMCIA card.
3.
Release the reset button.
4.
Verify that each array controller reinitializes.
Advertisement
Table of Contents
