Table of Contents
Advertisement
Table 5–6
Installing Two-Enclosure Subsystem
Cables (Continued)
5.
On the master enclosure
I/O module, align the
Cable A (C
ALLOUT
connector with the left
connector. Gently insert
the cable connector into
the module connector.
Tighten both cable
connector thumb screws
to fully seat the
connector.
6.
Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
7.
On the master enclosure, align the module that has Cable A
(C
A) attached with the Port 1 backplane connector. Gently
ALLOUT
insert the module and fully seat it. Use a screwdriver to tighten the
spring-loaded mounting screws.
6
5
8.
On the expansion I/O
module, align the Cable A
(C
A) connector
ALLOUT
with the left connector.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
9.
Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
Single-Ended I/O Module
A)
4
3
A
UltraSCSI RAID Enclosure 5–13
A
CXO5854B
2
1
A
CXO5854B
Advertisement
Table of Contents
