Table of Contents
Advertisement
Single-Ended I/O Module
5–18 UltraSCSI RAID Enclosure
Table 5–8
Installing Three-Enclosure Subsystem
Cables (Continued)
7.
On the master enclosure shroud, align the module that has Cable A
(C
A) attached with the Port 1 backplane connector. Gently
ALLOUT
insert the module and fully seat it. Use a screwdriver to tighten the
spring-loaded mounting screws.
6
5
8.
On the first expansion I/O
module, align the Cable A
(C
A) connector
ALLOUT
with the left connector.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
9.
Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
10. Using the expansion I/O module in step 8, align the Cable B
(C
B) connector with the right connector. Gently insert the
ALLOUT
cable connector into the module connector. Tighten both cable
connector thumb screws to fully seat the connector.
4
2
3
1
A
A
B
CXO5855B
CXO5854B
Advertisement
Table of Contents
