Compaq StorageWorks DS-BA370 Series User Manual page 121

Table 5–8 Installing Three-Enclosure Subsystem
Cables (Continued)
11. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
12. On the first expansion enclosure shroud, align the module that has
Cable B (C
ALLOUT
Gently insert the module and fully seat it. Use a screwdriver to
tighten the spring-loaded mounting screws.
6
5
6
5
6
13. On the second expansion
enclosure I/O module,
align the Cable B
(C B) connector
ALLOUT
with the left connector.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
14. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
Single-Ended I/O Module
B) attached with the Port 1 backplane connector.
4
3
A
4
3
B
4
UltraSCSI RAID Enclosure 5–19
2
1
2
1
2
A
CXO5854B