Setting Up Dial-In Access; Dial-In Setup - McAfee SG310 Administration Manual

Network Setup menu options

Setting up dial-in access

Figure 54 Connections – Alias tab — Interface Aliases
Click New. The Edit Interface Alias dialog appears
3
Figure 55 Edit Interface Alias dialog
Enter the alias address in the Alias IP Address field.
4
Enter the subnet mask for the alias in the Alias Subnet Mask field, The netmask can be either a number
5
between 0 and 32, or in the form 255.255.255.0. The Alias Subnet Mask defaults to your current subnet
mask.
Click Finish. The Aliased IP address is added to the edit list.
6
If necessary, you can continue to configure additional settings by clicking the IPv6 tab for the serial
port connection. See
Setting up dial-in access
A remote user can dial directly to a modem connected to the serial port of the UTM Firewall appliance. Once
connected and authenticated, the user has access to network resources as if they were a local user on the
LAN. This is useful for remote administration of your appliance, or for telecommuting.
Note: Concurrent Dialin and Dialout configurations are not currently supported. Dialin access uses the PPP
(Point-to-Point) protocol only. SLIP (Serial Line IP) and other protocols are not supported.

Dial-in setup

From the Network Setup menu, click Network Setup. The Connections tab opens.
1
From the Change Type list of the Connection you want to configure, select Dialin. The connection is the
2
interface you want to connect to the dialup modem to answer incoming calls.
The Dial-In Setup Account Details page appears
McAfee UTM Firewall 4.0.4 Administration Guide
Enabling IPv6 for a connection.
(Figure 55).
(Figure 56).
61