Leds; Physical Specifications; Utm Firewall Management Console - McAfee SG310 Administration Manual

Introduction

UTM Firewall Management Console

LEDs

The rear panel contains LEDs indicating status. The two LEDs closest to the network port are network
activity (upper) and network link (lower). The two other LEDs are power (upper) and heart beat (lower).
Table 5 SG640 LED descriptions
Location
Top right (Power
Bottom right
(Heart beat)
Top left (Network
activity)
Bottom left
(Network link)
Note: If the Heart Beat does not begin flashing shortly after power is supplied, refer to
upgrade.

Physical specifications

The following are the network link specifications:
• 10/100baseT Ethernet port
• Ethernet LEDs (link, activity)
The following are the environmental specifications:
• Status LEDs: Power, Heart Beat
• Operating temperature between 0° C and 40° C
• Storage temperature between -20° C and 70° C
• Humidity between 0 to 95% (non-condensing)
UTM Firewall Management Console
The features of your UTM Firewall appliance are configured and monitored using the UTM Firewall
Management Console. When you first browse to the Management Console, the Status page displays
(Figure 4). Here you can view the current system status of your UTM Firewall appliance. You can also view
the status of the UTM Firewall connections and the services that are running on it by selecting one of the
other two tabs that display on the Status page.
The menu displayed on the left side of every Management Console page is used to configure your UTM
Firewall appliance, or you can use the Quick Setup Wizard (see
configurations. Once you have completed the initial configuration, you can continue the setup using the
Guided Configurations that are available from the lower pane of the page.
16 McAfee UTM Firewall 4.0.4 Administration Guide
Activity Descriptions
On Power is supplied to the appliance.
Flashing The appliance is operating correctly.
On If this LED is on and not flashing, an operating error has occurred.
Off If the power is on and the H/B light is off, either the Halt Now option is activated
in preparation to power down safely, or an operating error has occurred.
Flashing Data is being transmitted or received.
On The appliance is attached to the network.
Recovering from a failed
Chapter 2, Getting Started) and the guided