McAfee SG310 Administration Manual page 174

Firewall menu options
NAT
Figure 176 Port Forwarding page — initial view
Thereafter, you can also use the add above or add below icon to add a rule above or below an existing rule.
If you use the New button, the rule is added to the bottom of the list. Use the up or down arrows to
reposition a rule. For more information on icons, see
you can edit and delete the rules as necessary
Figure 177 Port Forwarding page — populated view
Creating a basic port forwarding rule
Use this procedure to create a basic port forwarding rule. The rule is applied to all WAN interfaces and all
source addresses are matched.
If you want to specify the incoming interface and source address for matching incoming packets, use the
Advanced port forward page. In addition, if you want to disable the port forwarding rule from automatically
creating a packet filtering rule, follow the advanced procedure. For instructions, refer to
advanced port forwarding
When creating a rule, you can either use predefined addresses or services or manually enter an address or
service. To use the predefined definitions added through the Definitions menu, click Show Definitions by
the fields where applicable and select a definition from the list. For more information on definitions, see
Definitions. To manually enter an address or service, click New.
From the Firewall menu, click NAT. The Port Forwarding page appears.
1
If this is the first rule, click New. Otherwise, you can also click the add above or below icon to add the
2
rule in the location you want above or below an already defined rule. The Modify Port Forward page
appears (Figure
174 McAfee UTM Firewall 4.0.4 Administration Guide
rule.
178).
Interface icons. Once the page is populated with rules,
(Figure 177).
Creating an