Connecting With A Cable Modem - McAfee SG310 Administration Manual

Network Setup menu options

Connecting with a cable modem

Figure 45 ADSL Static Configuration
[Optional] Enter a descriptive name in the Connection Name field.
3
Enter the IP address provided by your ISP in the IP Address field.
4
Enter the IP address of the gateway provided by your ISP in the Subnet mask field.
5
Enter the IP address of the gateway provided by your ISP in the Gateway field.
6
Enter the DNS Address provided by your ISP in the DNS Server field. Separate multiple DNS addresses
7
with commas.
Select a classification from the Firewall Class list.
8
[Optional] Select the Preferred Gateway checkbox to enable load-balancing over this connection.
9
Click Finish. Additional configuration tabs appear, such as the VLAN configuration or Ethernet
10
configuration tab (depending on your connection type), Aliases, and IPv6. See
VLAN, Aliases
Connecting with a cable modem
Use this procedure to connect to the Internet using a cable Internet service. Cable Modem connections
have the interface firewall class of Internet.
Prerequisites: If you have not already done so, connect the appropriate network port of your UTM
Firewall appliance to your cable modem. Power on the cable modem and give it some time to initialize.
Ensure the Ethernet link LEDs are illuminated on both the UTM Firewall appliance (if applicable) and cable
modem.
From the Network Setup menu, click Network Setup. The Connections tab opens.
1
For the interface that you want to connect to your cable modem, select Cable Modem from the Change
2
Type list.
The Cable Model Connection Details page appears
3
or @Home, select the Generic Cable Modem Provider option.
54 McAfee UTM Firewall 4.0.4 Administration Guide
tab, and Enabling IPv6 for a connection.
(Figure 46). Select your cable ISP. If it is not BigPond
Ethernet Configuration tab,