Configuration Files Tab - McAfee SG310 Administration Manual

System menu features
Advanced menu
Upgrading the flash bootloader image from the UTM Firewall appliance
The UTM Firewall device stores a copy of the original bootloader image. You can use this stored image to
upgrade the bootloader flash region.
Use this procedure to upgrade the UTM Firewall's flash bootloader image using the image stored on the
unit.
From the System menu, click Advanced, select the Flash Upgrade tab and then the Upgrade from
1
Device tab
Figure 383 Upgrade from Device tab
Enter any Extra Parameters only at the request of McAfee technical support staff.
2
Click Upgrade. The firmware upload only accepts valid firmware images and only accepts newer images
3
appropriate for your device. Wait for the upgrade to complete.

Configuration Files tab

The Configuration Files tab provides direct and quick access to configuration files within the Edit Files tab.
The Filename column indicates the configuration file name. The Size column indicates the amount of
space on the configuration that a file is using. There is a limited amount of configuration space available on
an appliance. The Mode column indicates whether a file has read (r), write (w), and delete (x) access.
Caution: Exercise caution when manually editing configuration files. Manually modifying or deleting the
configuration files of your UTM Firewall appliance may render the appliance inoperable until a factory erase has
been performed.
Editing a configuration file
Use this procedure to manually edit configuration files within the Management Console. Binary files cannot
be selected and do not have an edit icon.
Caution: Make sure you edit in the "Custom entries below here" section if present in the configuration file.
To manually view or edit a configuration file:
368 McAfee UTM Firewall 4.0.4 Administration Guide
(Figure 383).