Configuring The Utm Firewall Switch - McAfee SG310 Administration Manual

Getting Started

Configuring the UTM Firewall switch

Fill out the fields:
10
• In the IP Address field, enter the static IP address you want to apply to the WAN port of the appliance.
• Enter the Subnet Mask to use for the WAN port.
• [Optional] Set the default Gateway Address.
• [Optional] Set the IP address of the Domain Name Server (DNS).
Click Next.
11
• The Switch Configuration page appears for most models. In this case, go to
Firewall
• If you are setting up a SG310, the Confirm Settings page appears. Go to
Configuring the UTM Firewall switch
The switch dialog displays if you are setting up the SG560, SG 560U, SG565 or SG580. If you are setting
up a different model, skip to
By default, the UTM Firewall's switch A behaves as a conventional switching hub. However, it may be
configured so that each port behaves as if it were physically separate from the others.
Figure 23 Quick Setup Wizard – Switch dialog
.
Select a configuration for the UTM Firewall's switch
1
• If you require multiple network segments, such as a DMZ, guest network, or second LAN; or if you
want to use multiple broadband Internet connections for Internet load balancing or Internet failover,
select 1 LAN Port, 3 Isolated Ports. Port A1 is used as the primary LAN connection.
• Otherwise, select 4 LAN Ports.
Click Next. The Firewall dialog appears
2
McAfee UTM Firewall 4.0.4 Administration Guide
switch.
Selecting an initial firewall level.
(Figure 23).
(Figure 24).
Configuring the UTM
Confirming settings.
29