McAfee SG310 Administration Manual page 227

Firewall menu options
Antivirus
From the Firewall menu, click Antivirus > Storage > Local Storage tab. The Local USB Storage page
1
appears (Figure 229).
Figure 229 Local USB Storage
Select the USB device or partition from the Device list and click Submit.
2
Creating a Windows user account
It is recommended a special user account is created for use by the UTM Firewall appliance for reading and
writing to the network share. If you have an existing account or want to make the network share readable
and writable by everyone, you can disregard this procedure. This procedure is for the Windows XP
operating system. Refer to Microsoft documentation for current information and more detail.
Click Start > Control Panel > User Accounts > Create a new account. Type a name for the new
1
account; for example sguser, and click Next.
Typically it is sufficient to grant this account Limited privileges.
2
Click Create Account.
3
Select the account you have just created under Pick an account to change.
4
Select Create a password. Enter and confirm a password for this account, as well as a password hint if
5
desired.
Creating a Windows XP network share
A network share is a shared folder or drive on a local Windows PC, or a PC running another operating
system capable of SMB sharing such as Mac OS X. For details on creating a network share on an OS other
than Windows, refer to the documentation for your operating system.
Launch Windows Explorer (Start > (All) Programs > Accessories > Windows Explorer) and open up
1
a folder or drive to dedicate as a network share for use by the UTM Firewall appliance.
Begin by disabling simple file sharing for this folder. From the Tools menu, select Folder Options. Click
2
the View tab and under the Advanced settings section clear Use simple file sharing
(Recommended). Click OK.
Next, share the folder. Right-click the folder and select Sharing and Security. Select Share this folder
3
and note the Share name; you can change this to something easier to remember if desired.
Finally, to set the security permissions of the newly created network share, click Permissions.
4
[Recommended] If you want to secure the network share with a user name and password, click Add and
5
type the user name the account to be used by the UTM Firewall appliance and click Check Names then
OK.
Select this account, or Everyone if you are not securing the network share with a user name and
6
password, and check Allow next to Full Control. Click OK and OK again to finish.
McAfee UTM Firewall 4.0.4 Administration Guide 227