Adopting An Adaptive Ap Using A Configuration File; Adopting An Adaptive Ap Using Dhcp Options - Motorola AP-51 Series Product Reference Manual

7. Click Apply to save the changes to the AAP setup.
NOTE The manual AAP adoption described above can also be conducted using

10.4.1.2 Adopting an Adaptive AP Using a Configuration File

To adopt an AAP using a configuration file:
1. Refer to Adopting an Adaptive AP Manually
parameters.
2. Export the AAP's configuration to a secure location.
Either import the configuration manually to other APs or the same AP later (if you elect to
default its configuration). Use DHCP option 186 and 187 to force a download of the
configuration file during startup (when it receives a DHCP offer).
For instruction on how to use the access point's configuration import/export functionality,
see Importing/Exporting Configurations on page
For information on updating the access point's firmware, see
Updating Device Firmware on page

10.4.1.3 Adopting an Adaptive AP Using DHCP Options

An AAP can be adopted to a wireless switch by providing the following options in the DHCP Offer:
Option Data Type
189 String
190 String
191 String
192 String
NOTE Options 189 and 192 are mandatory to trigger adoption using DHCP
the access point's CLI interface using the admin(system.aapsetup)>
command.
4-54.
<Switch IP Address or Range of IP addresses separated by [, ; <space>]>
<Fully qualified Domain Name for the Wireless Switch>
<Hashed IPSec Passkey - configure on 1 AP and export to get hashed key>
<Value of "1" denotes Non-IPSec Mode and "2" denotes IPSec Mode>
options. Unlike an AP300, option 189 alone won't work. These options can
be embedded in Vendor Specific Option 43 and sent in the DHCP Offer.
and define the AAP switch connection
4-49.
Value
Adaptive AP 10-15