Motorola AP-51 Series Product Reference Manual page 211

2. Enable the radio(s) using the
Review the Radio Function
radio (typical access point functionality) or has been dedicated as a WIPS sensor.
Refer to RF Band of Operation
or 802.11b/g radio. After the settings are applied within this Radio Configuration screen, the
Radio Status and
network, these values update in real-time.
CAUTION If a radio is disabled, be careful not to accidentally configure a new
!
3. Select the Base Bridge
connections from other access points in client bridge mode. The base bridge is the acceptor
Enable checkbox(es).
to determine if this radio is currently functioning as a WLAN
parameter to ensure you are enabling the correct 802.11a
MUs connected values update. If this is an existing radio within a mesh
WLAN, expecting the radio to be operating when you have forgotten it
was disabled.
checkbox to allow the access point radio to accept client bridge
Network Management 5-53