Configuring Lan1 And Lan2 Settings - Motorola AP-51 Series Product Reference Manual

frame arrives on the access point, it queries the VMPS for the VLAN assignment based on
the source MAC address of the arriving frame.
If statically mapping VLANs, leave the
its intended VLAN unselected. The administrator is then required to configure VLAN
memberships manually.
The Dynamic checkbox is enabled only when a WLAN is having EAP configured. Otherwise,
the checkbox is disabled.
12. Use the VLAN
listed on the left-hand side of the screen.
Motorola recommends mapping VLANs strategically in order to keep VLANs tied to the
discipline they most closely match. For example, If WLAN1 is comprised of MUs supporting
the sales area, then WLAN1 should be mapped to sales if a sales VLAN has been already
been created.
13. Click Apply to return to the
at the LAN screen, click

5.1.2 Configuring LAN1 and LAN2 Settings

Both LAN1 and LAN2 have separate sub-screens to configure the DHCP settings used by the LAN1
and LAN2 interfaces. Within each LAN screen is a button to access a sub-screen to configure
advanced DHCP settings for that LAN. For more information, see
Settings on page 5-13. Additionally, LAN1 and LAN2 each have separate
used to prevent specific (an potentially unneccesary) frames from being processed, for more
information, see Setting the Type Filter Configuration on page
To configure unique settings for either LAN1 or LAN2:
1. Select Network Configuration
tree.
drop-down menu to select the name of the target VLAN to map to the WLAN
VLAN Name
Apply to re-apply your changes.
-> LAN
Dynamic checkbox specific to the target WLAN and
screen. Click OK to return to the LAN screen. Once
Configuring Advanced DHCP Server
5-15.
-> LAN1 (or LAN2)
Network Management
Type Filter submenu items
from the access point menu
5-9