Motorola AP-51 Series Product Reference Manual page 69

CAUTION Motorola recommends care be taken not to damage the finished
!
7. Remove the light pipe's rubber stopper before installing the light pipe.
8. Connect the light pipe to the bottom of the AP-5131. Align the tabs and rotate approximately
90 degrees. Do not over tighten.
9. Snap the clips of the light pipe into the bottom of the AP-5131.
10. Fit the light pipe into hole in the tile from its unfinished side.
11. Place the decal on the back of the badge and slide the badge onto the light pipe from the
finished side of the tile.
12. Attach the radio antennae to their correct connectors.
CAUTION Both the Dual and Single Radio model AP-5131s use RSMA type
!
surface of the ceiling tile when creating the light pipe hole and
installing the light pipe.
antenna connectors. On the Dual Radio AP-5131, a single dot on the
antenna connector indicates the primary antenna for both Radio 1 (2.4
GHz) and Radio 2 (5 GHz). Two dots designate the secondary antenna
for both Radio 1 and Radio 2. On Single Radio models, a single dot on
the antenna connector indicates the primary antenna for Radio 1, and
two dots designate the secondary antenna for Radio 1.
Light Pipe
Decal
Badge
Hardware Installation 2-21
Ceiling Tile