Applying A Filter To Lan1, Lan2 Or A Wlan (1-16) - Motorola AP-51 Series Product Reference Manual

5-78 AP-51xx Access Point Product Reference Guide
NOTE Once filter policies have been defined, they can then be applied to traffic
3. If necessary, select an existing policy and select the
filtering policy from those available.
4. Click Apply
without clicking Apply results in all changes to the screens being lost.
5. Click Undo Changes
6. Click Logout
logout before the applet is closed.

5.6.1 Applying a Filter to LAN1, LAN2 or a WLAN (1-16)

Once filter polices are defined, they must be applied to a LAN or WLAN within the LAN1 or LAN2
screens, or within the WLAN's New/Edit screens, not from within the main IP Filtering menu.
To apply an existing IP filter policy to LAN1, LAN2 or a WLAN:
1. Display the IP Filtering menu.
From the LAN1 or LAN2 screen:
a. Select
menu tree.
b. Select the
c. Select the
From the Wireless screen:
a. Select
b. Click the
and click the
c. Select the
d. Select the
on either of the two access point LAN ports or any of the 16 access point
WLANs. The procedure for applying a filtering policy is the same, as both
the LAN1/LAN2 and WLAN screens display the same IP Filtering sub
screen for this operation. For more information, see
LAN1, LAN2 or a WLAN (1-16) on page
to save any changes to the IP Filtering screen. Navigating away from the screen
to securely exit the IP Filtering screen without saving your changes.
to securely exit the Access Point applet. A prompt displays confirming the
Network Configuration
Enable IP Filtering
IP Filtering button.
Network Configuration
Create button to apply the filter to a new WLAN, or highlight an existing WLAN
Edit button. Either the
Enable IP Filtering
IP Filtering button.
5-78.
Del button to permanently remove the
-> LAN -> LAN1 (or LAN2)
button in the lower, right-hand side of the screen.
-> Wireless from the access point menu tree.
New WLAN or Edit WLAN
button in the lower portion of the screen.
Applying a Filter to
from the access point
screen displays.