5-2
AP-51xx Access Point Product Reference Guide
For information on locating the access point's MAC addresses, see
7-2
and
Viewing LAN Statistics on page
Use the
LAN Configuration
assign them names, define which LAN is currently active on the access point Ethernet port and assign
a timeout value to disable the LAN connection if no data traffic is detected within a defined interval.
To configure the access point LAN interface:
1. Select
Network Configuration
CAUTION If deploying the access point as an AAP with a remote layer 3
!
7-6.
screen to enable one (or both) of the access point's LAN interfaces,
->
LAN
configuration and the AAP is set for switch auto discovery
(primary/standby), the access point will un-adopt from its switch after
a few moments. To remedy this problem, ensure LAN1 has 802.1q
trunking enabled and the correct management VLAN defined.
Viewing WAN Statistics on page
from the access point menu tree.