Motorola AP-51 Series Product Reference Manual page 538

8-180 AP-51xx Access Point Product Reference Guide
AP51xx>admin(system.snmp.traps)> add
Description:
Adds SNMP trap entries.
Syntax:
add v1v2 <ip>
Adds an entry to the SNMP v1/v2 access list with the destination IP address set to <ip>, the destination UDP port set to
<port>, the community string set to <comm> (1 to 31 characters), and the SNMP version set to <ver>.
v3 <ip>
Adds an entry to the SNMP v3 access list with the destination IP address set to <ip>, the destination UDP port set to
<port>, the username set to <user> (1 to 31 characters), and the authentication type set to one of none, auth, or
priv.
The following parameters must be specified if <sec> is not none:
Authentication type <auth> set to
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv:
Privacy algorithm set to
Privacy password <pass2> (8 to 31 chars)
Example:
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index dest ip
----------------------------------------------------------------------
1 203.223.24.2
admin(system.snmp.traps)>add v3 201.232.24.33 555 BigBoss none md5
admin(system.snmp.traps)>list v3 all
index
destination ip
destination port
username
security level
auth algorithm
auth password
privacy algorithm
privacy password
For information on configuring SNMP traps using the applet (GUI), see
<port> <comm> <ver>
<port> <user> <sec>
des or aes
dest port
333
<auth> <pass1>
md5 or sha1
community
mycomm
: 1
: 201.232.24.33
: 555
: BigBoss
: none
: md5
: ********
: des
: ********
Configuring SNMP RF Trap Thresholds on page
<priv> <pass2>
version
v1
4-41.
auth/