Connecting To The Cli; Accessing The Cli Through The Serial Port; Accessing The Cli Via Telnet - Motorola AP-51 Series Product Reference Manual

8-2 AP-51xx Access Point Product Reference Guide

8.1 Connecting to the CLI

8.1.1 Accessing the CLI through the Serial Port

To connect to the access point CLI through the serial port:
1. Connect one end of a null modem serial cable to the access point's serial connector.
NOTE If using an AP-5131 model access point, a null modem cable is required. If using an AP-5181
2. Attach the other end of the null modem serial cable to the serial port of a PC running HyperTerminal or a similar emulation
program.
3. Set the HyperTerminal program to use 19200 baud, 8 data bits, 1 stop bit, no parity, no flow control, and auto-detect for
terminal emulation.
4. Press <ESC> or <Enter> to enter into the CLI.
5. Enter the default username of
point, you are unable to access any of the access point's commands until the country code is set. A new password will also
need to be created.

8.1.2 Accessing the CLI via Telnet

To connect to the access point CLI through a Telnet connection:
1. If this is your first time connecting to your access point, keep in mind the access point uses a static IP WAN address
(10.1.1.1). Additionally, the access point's LAN port is set as a DHCP client.
2. Enter the default username of
point, you are unable to access any of the access point's commands until the country code is set. A new password will also
need to be created.
model access point, an RJ-45 to Serial cable is required to make the connection.
admin and the default password of motorola. If this is your first time logging into the access
admin and the default password of motorola. If this is your first time logging into the access