Tools Needed for Installation
To install the system, you must have the following tools:
No. 2 Phillips screwdriver
■
ESD mat and grounding strap
■
You must also provide a system console device, such as one of the following:
ASCII terminal
■
Workstation
■
Terminal server
■
Patch panel connected to a terminal server
■
Related Information
"ESD Precautions" on page 20
■
"Server Handling Precautions" on page 19
■
Optional Component Installation
Optional conponents that are ordered as part of the server's initial configuration will
be installed in the server before it is shipped. However, if you place a separate order
for optional components, you will need to install them in the server on site. See the
service manual for instructions on installing optional components.
Tip – If possible, install any additional components in the server before you install
the server in its rack or cabinet.
Related Information
"Tools Needed for Installation" on page 21
■
Preparing for the Installation
21
Need help?
Do you have a question about the SPARC T3-1 and is the answer not in the manual?