Assign A Static Ip Address To The Service Processor - Sun Oracle SPARC T3-1 Installation Manual

▼ Assign a Static IP Address to the
Service Processor
If the network your server is connected to does not support DHCP for IP addressing,
perform the following procedure to update the OS configuration to static IP
addressing and to assign a static IP address to the service processor.
1. Set the service processor to accept a Static IP Address.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
2. Set the IP address for the service processor.
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
3. Set the IP address for the service processor gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
4. Set the netmask for the service processor.
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
This example uses 255.255.255.0 to set the netmask. Your network
environment subnet might require a different netmask. Use a netmask number
most appropriate to your environment.
5. Use the show /SP/network command to verify that the parameters were set
correctly.
-> show /SP/network
/SP/network
60 SPARC T3-1 Server Installation Guide • March 2012
Targets:
interconnect
ipv6
test
Properties:
commitpending = (Cannot show property)