Table of Contents
Advertisement
Step 5.
When the mast is lowered, make sure the mast is properly supported to pre-
vent it from scratching your boat or beams.
2.2. Rigging the boat
2.2.1. Spinnaker pole
Step 1.
Take the spinnaker pole and put it through the middle spi pole bridles that
are attached to both hulls. Then put it on the spinnaker pole pin on the front
beam. Make sure the jib sheet is on top of the spinnaker pole!
CAUTION: Check for overhead wires and be sure the area behind the boat is clear of people! A mast which comes in contact with elec-
trical power lines can cause serious injury or death.
Spinnaker pole
Step 1
Step 4 and 5
Support the mast
Step 1
Jib sheet on top of spinnaker po-
le!
50
Advertisement
Table of Contents
