Raising The Jib - Nacra F20 Carbon Assembly & Rigging Manual

Step 3.
Take the other end of the spinnaker halyard and put it through the two rings
in the spinnaker. Then tie it down to the top path as shown on the picture.
Step 4.
Follow the trailing edge of the spinnaker, take the clew of the spinnaker and
then tie the spinnaker sheet down to it as shown on the picture. Make sure
both ends of the spinnaker sheet run around the forestay and above all the
bridle wires.

2.3.2. Raising the jib

Step 1.
Take the jib halyard and make sure the halyard is not tangled or turned. It
should be running free to the halyard ring in the top of the mast.
Step 2.
Make sure your boat is facing the wind and then connect the jib halyard to
the jib. The top of the S-hook should be facing backwards, because the jib
will not lock otherwise. Look at the picture!
Step 3.
Pull on the halyard a bit and close the zipper around it. Make sure the
halyard is also inside the zipper.
Step 4
Step 3
Raising the jib
Step 1, 2 and 3
Also put the halyard in the zip-
per!
58