Fixing The Stays; Jib Halyard - Nacra F20 Carbon Assembly & Rigging Manual

1.6.7. Fixing the stays

Step 1.
Take the big shackle, the forestay, two side stays and plastic washers from
the box.
Step 2.
Place the forestay in the shackle and make sure the part of the fore stay with
the ring is on the bottom.
Step 3.
Place the two side stays next to both sides of the forestay.
Step 4.
Attach the shackle to the mast hound in the bottom hole. Use plastic washers
on both sides. Tighten the shackle firmly and secure it with some thin wire to
make sure it does not come off. Put some tape around the thin wire!.

1.6.8. Jib halyard

Step 1.
Take the jib halyard and put it through the eyelet in the top of the forestay.
Step 2.
Take both ends through the ring under the eyelet.
Step 4
Fixing the stays
Step 1,2 and 3
Make sure the part of the fores-
tay with the ring is closest to the
mast!
Jib halyard
Step 1 and 2
26