Nacra F20 Carbon Assembly & Rigging Manual page 51

Step 2.
Attach the spinnaker connector rod hanging under the forestay to the con- Step 2
nection point near the middle spinnaker bridle wires. Make sure to tape the
ring!
Step 3.
Connect the two spinnaker pole bridle wires on the front end of the spi pole
to the hulls with two clevis pins. Don't forget to tape the rings! Also take the
spin pole line and tie it to the spinnaker pole in front of the spinnaker shute
(look at picture for location). Then go through the rail in the spinnaker shute
and tie the line to the bridle tank putting. Make sure there is some tension
on the line to prevent the spinnaker pole from twisting to much while sailing.
51