4. Rigging
4.1 preparation
5.
Attach the schrouds to the staymaster to the
staymaster use the clevispin 1/4 x 5/8 WL .
Make sure the staymaster is at his maximum
length:10!
1.
Mount the bridle wires, stay adjuster and
compression pole on the bridle connecti-
on fitting.
Use the clevis pins 1/2 x 1/4
2.
Adjust the ring 3x20 ss under the bridle
on each side as shown in the picture.
Note: The F18 Infusion has no compressi-
on pole and bridle connection fitting but
a spi pole holder ring.
3.
4.
6.
7.
NACRA EMPOWERING SAILORS SINS 1975
Place the mast with care on the trampoline with
the masttrack down, support the back of the
mast to prevent it from scratching!
Check if the rigging and the shackles are
connected on the mast as have shown in the
manual.
10
Attach the adjustable trapeze to the trapeze
wires.
Check page ...how to assemble the sys-
tem.
Tie the adjustable trapeze wire to the trapeze
shockcords.
Check if the shrouds and trapeze wires are in
the right order before raising the mast!!