Table of Contents
Advertisement
1.3.4. Front beam pre-bend
There should always be pre-bend on the front beam. This is done by tensio-
ning the pin of the dolphin striker. After each session the first three ti-
mes the boat is sailed the following procedure MUST be completed
(with the mast taken off!):
Dolphin striker pin
Step 1.
Unscrew the nuts above and under the front beam on the dolphin striker pin.
Make sure there is exactly 25 mm between the top of the front beam and
the bottom of the top nut (see picture)
Step 2.
Screw the nut below the dolphin striker up until both screws are tight against
the front beam. You have now set pre-bend to the front beam.
9
Advertisement
Table of Contents
