Rigging; Preparation - Nacra F18 Evolution Assembly Manual

4. Rigging

4.1 Preparation

Tools needed:
- Allen tool size 3 - Wrench 11mm
1. Mount the bridle wires on the bridle connector.
Use the clevis pins 1/2 x x 1/4.
2. Install the ring 3x20 ss under the fork terminal
on port side as shown in the picture.
3. Place the mast with care on the trampoline with
the masttrack down, support the back of the
mast to prevent it from scratching!
26
4. Check if the rigging and the shackles are
connected on the mast as shown in 2.7 Fixing
the stays.
5. Attach the turnbuckle to the shroud eye
and make sure you attach the ring from the
continues mast rotation system on the inside of
the turnbuckle.
• Make sure the turnbuckle is at his maximum
length of 0!
6. Install the adjustable trapeze with the shackle to
the trapeze line. Check page 51 how to assemble
the trapeze system.
7. Knot the adjustable trapeze line to the trapeze
shockcords.
Check if the shrouds and trapeze lines are in
the right order before raising the mast!