Fixing The Mast Rotation Cleats; Mounting The Staymasters - Nacra F20 Carbon Assembly & Rigging Manual

Step 5.
After hand tightening the bolts, work your way around the boat and tighten
all the beam bolts to about 24 Nm on the torque wrench. Do not exceed the
recommended 24 Nm as over tightening results in damaged threads.

1.3.2 Fixing the mast rotation cleats

Get the two mast rotation cleats from the rigging box and screw them in the
pre drilled holes in the hull, which are located about 80 cm behind the front
beam.

1.3.3. Mounting the staymasters

Mount the staymaster onto the hull with the bolt and nut. Make sure the nut
is inboard. Tighten it firmly, but make sure the staymaster is still able to turn
a little.
Fixing the mast rotation cleats
Step 5
Placing the side stay adjusters
8