Table of Contents
Advertisement
1.8. Ropes and halyards
1.8.1. Spinnaker sheet
Step 1.
Take two blocks and the spinnaker sheet blocks. Install the two blocks on
the front beam and install the spinnaker sheet blocks on the hulls. Connect
the two blocks with the short shock cord supplied.
Step 2.
Take one end of the spinnaker sheet and put it through the spinnaker sheet
block on the hull. Make sure you put it through the right way (the block only
works one way). Also do this for the other side.
Step 3.
Go through the spinnaker sheet block on the front beam. Also do this for the
other side.
Step 4.
Tie a spinnaker tension shock cord to the middle of the spinnaker sheet. Ma-
ke sure the knot can not move, so tighten it properly!
Step 5.
Take the other end of the shockcord through the hole in the trampoline and
go under the trampoline.
Step 6.
Take the shockcord through the hole on the right, rear corner of the trampo-
line and leave it there for a moment. We will attach the tack line to this
shockcord later on in the manual.
1.8.2. Spinnaker retrieve block
Step 1.
Take a block and the spinnaker tension shock cord and tie the block to the
middle of the shock cord.
Step 4,5 and 6
Tighten the knot properly!
Spinnaker sheet
Step 1, 2 and 3
Spinnaker retrieve block
Step 1
Go under the foot strap!
35
Advertisement
Table of Contents
