Mainsail Halyard - Nacra F20 Carbon Assembly & Rigging Manual

Step 4.
Take the spinnaker block line and tie it to the top of the block. Tie the other
end to the eyelet in the top of the mast. Make sure this line is tight when the
spinnaker halyard block is pulled down. Test this by pulling the block down.
Step 5.
Take some wear tape and place it underneath the spinnaker halyard block.
Make sure the tape covers the area of the mast when the block is pulled
down by the spinnaker!

1.6.6. Mainsail halyard

Step 1.
Mount the wheel for the mainsail halyard in the top of the mast with a clevis
pin.
Step 2.
Take the mainsail halyard and slide it through the mast; starting at the top.
Don't forget to go through the mainsail lock. Take a screwdriver and guide
the halyard to the bottom of the mast. Make sure the halyard is in the sail
track.
Tight line!
Mainsail halyard
Step 1
Step 4 and 5
Step 2
Also go through the mainsail
lock!
24