Part 2. Rigging; Raising The Mast; Preparing - Nacra F20 Carbon Assembly & Rigging Manual

Part 2. Rigging

The manual now continues with the boat as we left it in Part 1, so if you
don't exactly know how everything was supposed to be just check it in Part
1!

2.1. Raising the mast

2.1.1. Preparing

Step 1.
Take the two bridle wires, the connection rod for the spinaker pole and the
fore stay adjuster and mount them together as shown on the picture.
Step 2.
Connect the bridle wires to the hulls and attach the two spinaker pole bridle
wires as shown in the picture. Don't forget to tape the rings!
Step 3.
Take the mast and place the mast base on the trampoline, near the mast ball
on the front beam. Support the back of the mast, to prevent is from scrat-
ching the beam. It is best to place the mast in such a way that the sail track
is on the bottom and the front of the mast is up, because this will make it
easier to see in which order the stays and trapeze wires should be attached.
Check that the stays are connected the right way on the mast hound and the
shackles are tightened properly.
Step 2
Tape the rings!
Preparing
Step 1
Step 3
Check that the stays are connec-
ted the right way!
Doublecheck everything!
43