Spinnaker Block - Nacra F20 Carbon Assembly & Rigging Manual

1.6.5. Spinnaker block

Step 1.
Take the spinnaker bale line and a block. Slide the spinnaker bale line in one
of the pre-drilled spinnaker bale line holes and let it come out in the hole on
the other side. Tie a figure 8 knot to prevent it from sliding back again.
Step 2.
Take the other end of the spinnaker bale line and take it through the middle
of the block.
Step 3.
Go around the mast with the spinnaker block line and slide it through the
hole we just used next to the previous one. Let it come out on the other side
again and tie a figure 8 knot.
Spinnaker block
Step 1,2 and 3
Step 9
Step 1,2 and 3
23